PS 1006 provides clean DC power to sensitive equipment, and at the same time charges the battery bank and supplies power during mains failure. PS 1006 contains a 19” subrack that can house up to 6 hot-plugged rectifiers, a V/A meter or controller, and an LVD device.
PS 1006 is available in two configurations, with a V/A meter or with the System Controller 1006. An optional 1006 NET controller offers SNMP over TCP/IP communication and user-defined RS232 or SNMP communication.
Features
- Up to 6 hot-plugged rectifiers
- Universal input voltage
- Active current sharing
- Built-in dual 70A electronic low voltage disconnect device (ELVD) for battery protection
- High-performance, hot-plugged system controller (SC 1006) used to measure, monitor, and control AC and DC voltages, currents (load, battery, rectifiers), power, temperature, battery parameters, and additional data
- Temperature compensation for extended battery life
- Up to two battery sets handled in one system
- Automatic and pre-programmed battery test for each battery set
- Automatic and pre-programmed equalize charging mode
- Battery/load terminals protected by a dedicated thermal-magnetic circuit breaker
- RS232 (SC 1006) or TCP/IP (SC 1006 NET) communication
System Controller SC 1006 (Standard)
- Large, bright three-digit display
- Control of e-LVD(s)
- Periodic or manual battery check
- DC voltage compensation according to battery temperature
- Two temperature sensors for reliable measurement
- Indicator LEDs on the front panel
- Audible alarm
- Calibration by software (all-digital, no analog potentiometers)
- Graphic user interface (GUI)
- Real-time-clock (RTC) with backup
- Event log
- RS232 serial port
Measurements and Indications
- DC voltage
- Load current
- Battery current
- Rectifiers current
- Power (in Watts)
- AC voltage and frequency
- Status of input, output, e-LVD, rectifiers, battery, system breakers
- Battery temperature
- Breaking alert by modem
- Dry-contact signals (three alarms)
Control
- Battery test
- Two charging modes (FL, EQ)
- DC voltage setting (EQUALIZE or FLOAT charge modes)
- ELVD threshold setting (connect, disconnect)
- Unconditional control of each ELVD
System Controller 1006 NET (optional)
In addition to the standard features, the NET model offers:
- SNMP - TCP/IP communication
- User defined communication: RS232 or SNMP (PPP / 10baseT)